What does an AC relocation in Jubail include?
A Jubail relocation covers 6 steps: refrigerant pump-down, disconnection, transport, reinstallation, a fresh vacuum test and a cooling check at the new address, plus a coil check if the unit is moving into the industrial zone.
Pump-down draws the refrigerant back into the outdoor unit before disconnection begins, keeping the existing charge intact rather than releasing it to the air. That charge travels with the unit and gets reused at the destination when the new piping run is close in length.
A unit moving out of a residential district and into the industrial zone gets its condenser checked on arrival. The destination's air carries petrochemical particulate its old address never did, and that check adds a step a purely residential move does not need.
Remounting happens once the crew reaches the destination: the bracket goes up first, then the copper run is reconnected and pressure-tested. Air or moisture that entered during transport gets pulled out before the unit is switched back on.
For a move between two industrial-zone sites, both addresses need their own safety certificate cleared, not only the destination's.
- Pump-down
- Recovering the sealed refrigerant charge into the outdoor unit ahead of disconnection, so nothing is released or wasted.
- Disconnection
- Detaching indoor and outdoor units from their mounts and lines, with every open port capped for the trip.
- Reinstallation
- Fitting both units at the destination on properly rated brackets, to the same standard the first installation used.
- Vacuum test
- Confirming the reconnected circuit holds a clean vacuum, proof that nothing leaked in during transport, before power goes back on.
- Coil condition check
- An added Jubail step: the condenser is inspected for oily film at the new address, since exposure differs address to address.
How does the relocation process run step by step?
The relocation runs in 6 steps over roughly 180 minutes for a split unit, longer for a cassette or cabinet system, and the crew adds a coil check before signing off if the new address sits inside the industrial zone.
- 0115 min
Pump down and cap the circuit
Both service ports are capped once the charge sits safely in the outdoor unit.
- 0220 min
Disconnect and wrap both units
Padded wrapping goes on before either unit leaves the wall or bracket.
- 0330 min
Transport to the new address
Travel time depends on the distance between the two Jubail addresses involved.
- 0425 min
Remount the outdoor bracket
The bracket is levelled and bolted at the new site, to the same standard as a fresh install.
- 0540 min
Reconnect piping and vacuum test
The circuit is pulled to vacuum for 20 minutes before the refrigerant valve reopens.
- 0650 min
Commission, coil check and cooling test
Supply-air temperature is measured, and the condenser is inspected if the new site borders the industrial zone.
How much does AC relocation cost in Jubail?
Relocating a 1.5-ton split unit in Jubail runs 300 to 550 SAR and takes 180 minutes, plus the 30 SAR citywide travel surcharge that reflects the 130-minute average arrival from our Dammam base to any Jubail address.
Prices below cover labour, transport between the two addresses and standard remounting for one unit. Any new bracket, extended piping or replacement part is itemised separately, alongside VAT at 15%, on a quote issued in English.
| Unit type | Price range | Duration |
|---|---|---|
| Split, 1.5 ton | 300–550 SAR | 180 min |
| Split, 2 ton | 360–660 SAR | 196 min |
| Cassette, 1.5 ton | 510–935 SAR | 306 min |
| Cabinet, 1.5 ton | 450–825 SAR | 270 min |
Why does relocation cost more in Jubail than in Dammam or Khobar?
Jubail carries a 30 SAR travel surcharge, the same banding applied beyond the 110-minute free-arrival radius, reflecting both the 130-minute average arrival from our Dammam base and the extra coordination an industrial-zone move always needs.
The surcharge itself is a fixed banding, not a Jubail-specific markup. Any city with an average arrival past 110 minutes carries the same 30 SAR fee, and Jubail sits well inside that band at 130 minutes.
What is specific to Jubail is the coordination layer stacked on top of that travel time. A relocation between two industrial-zone sites needs both addresses' safety certificates cleared before the crew can even schedule a departure time.
A relocation entirely within a residential district skips that certificate step and moves closer to the standard citywide timeline. The extra coordination cost concentrates on industrial-to-industrial moves, not on every Jubail relocation equally.
When should you relocate a Jubail unit instead of buying new?
5 conditions favour relocating over replacing in Jubail: the unit is under 6 years old, it has no repeat fault history, the new site's load matches the old one, its warranty is active, and moving costs less than a comparable new unit delivered to site.
A unit already flagged for high head pressure is a poor relocation candidate before that fault is diagnosed. The same reading tends to resurface at the new address. AC Maintenance & Repair in Jubail covers that pressure check before a move is booked.
- The unit is under 6 years old and has no repeat fault history
- A household or business is moving within the same city
- The new site's load is similar to the one the unit is leaving
- The unit's warranty period has not yet expired
- Buying new at the destination would cost more than moving the existing unit
Which districts in Jubail do you serve for relocation?
Coverage reaches 7 districts across Jubail, from Al Fanateer at 90 minutes to the Industrial Area at 110, and a relocation crew confirms site permits at both the departure and arrival address before travel begins.
Dammam districts and arrival time per district
- Al Fanateer
- 90 min
- Al Deffi / Al Riyadh
- 95 min
- Al Huwailat / Al Jalmudah
- 100 min
- Al Buhayrah
- 105 min
- Industrial Area
- 110 min
What if the relocated unit needs sizing checked at the new address?
A unit sized for a small office may undersize a larger commercial floor at the new address, and that mismatch calls for a sizing review under installation — the same 6-step process as a brand-new unit — rather than a straight reinstallation.
A relocated unit that runs constantly without reaching the set temperature at its new address is usually a sizing mismatch, not a fault. AC Installation in Jubail covers that review, using the same sizing method applied to a brand-new unit.
Frequently asked questions
How much does AC relocation cost in Jubail?
A 1.5-ton split unit costs 300 to 550 SAR and takes 180 minutes, plus a 30 SAR citywide travel surcharge.
Why is there a travel surcharge on Jubail relocations?
A 30 SAR surcharge applies citywide, the same banding used for any city beyond the 110-minute free-arrival radius, reflecting Jubail's 130-minute average arrival.
Do you reuse the existing refrigerant charge?
Yes, when the piping run at the new address is a similar length. The charge is pumped down and reused rather than vented and replaced.
Do industrial-zone moves need extra permits?
Yes. A move between two industrial-zone sites needs both addresses' safety certificates cleared before the crew can schedule a departure time.
What warranty applies to a relocated unit?
A 90-day workmanship warranty covers the reinstalled unit's operation at its new address, the same warranty a fresh installation carries.
Should I relocate my unit or buy a new one?
Relocation makes sense under 6 years of age with no repeat fault history. Past that point, a new unit often costs less than moving and recommissioning an ageing one.